Search UandiStar

2

MICROPROCESSORS AND INTERFACING (MPI) LAB Manual including VIVA Questions

  • websites
  • Share

  • MICROPROCESSORS AND INTERFACING (MPI) LAB Manual including VIVA Questions


    I. Microprocessor 8086 :
    1. Introduction to MASM/TASM.
    2. Arithmetic operation – Multi byte Addition and Subtraction, Multiplication and Division – Signed and
    unsigned Arithmetic operation, ASCII – arithmetic operation.
    3. Logic operations – Shift and rotate – Converting packed BCD to unpacked BCD, BCD to ASCII
    conversion.
    4. By using string operation and Instruction prefix: Move Block, Reverse string, Sorting, Inserting, Deleting,
    Length of the string, String comparison.
    5. DOS/BIOS programming: Reading keyboard (Buffered with and without echo) – Display characters,
    Strings.
    II. Interfacing :
    1. 8259 – Interrupt Controller : Generate an interrupt using 8259 timer.
    2. 8279 – Keyboard Display : Write a small program to display a string of characters.
    3. 8255 – PPI : Write ALP to generate sinusoidal wave using PPI.
    4. 8251 – USART : Write a program in ALP to establish Communication between two processors.
    III. Microcontroller 8051
    1. Reading and Writing on a parallel port.
    2. Timer in different modes.
    3. Serial communication implementation.
    Equipment required for Laboratories:
    1. 8086 μP Kits
    2. 8051 Micro Controller kits
    3. Interfaces/peripheral subsystems
    i) 8259 PIC
    ii) 8279-KB/Display
    iii) 8255 PPI
    iv) 8251 USART
    4. ADC Interface
    5. DAC Interface
    6. Traffic Controller Interface
    7. Elevator Interface

    Download MICROPROCESSORS AND INTERFACING (MPI) LAB Manual including VIVA Questions

    2 Responses to “MICROPROCESSORS AND INTERFACING (MPI) LAB Manual including VIVA Questions”

    Post a Comment

    Add your valuable comment here, ask any questions about this post,
    Share your opinions here.
    Dont write any Phone numbers in comment...


    Subscribe